All of the sides were finish cut and beveled and such.
Hinge placement was worked out and channels were routed into the bases and sides.
Joe spent the day trimming down screws so we would get a full bite out of the 1/2" MDF.
Let's take a moment to discuss something very important to the process:
Safety
Always wear the appropriate protection when going about this sort of creativity. Note the wireless headphones to protect oneself from the crushing boredom of silence.
Also we should point out that it is a good idea to wear a red shirt. That way if -god forbid- you were to expire due to a power tool event, the authorities would immediately recognize that you were not in charge of this "away mission" and would continue to look for the responsible party.
No comments:
Post a Comment